2.3. ASSEMBLY AND PREPARATION FOR USE, (continued)
Space bar controls selection for MODE column and STATUS column. Mode column is toggled between
"YES" (notifies operator of secure and access changes by beeping and flashing text) and "NO" (does not
beep or flash text to notify operator of secure and access changes). STATUS column is toggled between
"ON" (monitors the area, ONLINE) and "OFF" (does not monitor area).
Press <Tab> key and press space bar to set status.
Press <F6>.to enter area notes and information.
Only a type over function is provided. In addition, ASCII II characters can be used to enter graphic
boxes. Refer to manuals provided with personal computer for ASCII II numbers. Enter ASCII characters
by holding down ALT key and entering associated ASCII II number on the keypad with <Num Lock > off
for character desired.
Use keyboard to enter area notes and information (maximum one screen per area).
Repeat steps i, (1) through i.(7) for each area to be monitored.
When SETUP MENU is displayed, configure system as follows:
Either press <3> or press down arrow (Jo) to highlight "System Setup".
When System Setup appears, use up and down arrow (T and 1) keys to select item for data entry.
Select items for configuration as follows:
Select the security display sorting method by pressing space bar.
This displays the list of status changes and alarms by priority.
Alarms, then Priority
This displays the alarms in order of occurrence then priority.
Press down arrow key (J) to highlight "Status Report Printing".
Select method of printing status reports by pressing space bar. Status reports can be printed by
specifying times or intervals.
XX:XX XX:XX XX:XX
Selects time intervals in increments of 10 minutes and
prints current status report during the selected time.
Every X Hours starting
Selects an hourly time interval from time entered and
prints current status report at the selected hourly time
Every Hour starting
Current Status Report is printed every hour from the
Change 1 2-8