TM 10-5411-207-14
Section V. MAINTENANCE INSTRUCTIONS
Subject
General . . . . . . . . . . . . . .
General Repair Procedures .
Shelter Assembly
Overall Shelter Assembly . .
Drip Molding (Above Door) .
Hand Hold (Roof) . . .
T-Latch Assembly . .
Drain Plug . . . . . . .
Plates
Hinge Assembly . . . .
Door Assembly
Emergency Exit Panel
Door Latch Assembly
Keeper Assembly . . .
Door Brace Assembly
Assembly .
Recessed Step Pan Assembly . . .
Towing Eye Assembly . . . . . . . .
Lifting and Tiedown Eye Assembly
Skid Assembly
Hold Down Assembly .. . . . . . . .
Touch-Up Painting . . . , . . . , , .
Para
3-8
3-9
3-10
3-11
3-12
3-13
3-14
3-15
3-16
3-17
3-18
3-19
3-20
3-21
3-22
3-23
3-24
3-25
3-26
3-27
3-28
Page
3-7
3-8
3-17
3-19
3-21
3-22
3-24
3-25
3-27
3-29
3-31
3-38
3-43
3-47
3-49
3-52
3-54
3-55
3-56
3-59
3-61
3-8.
General. Since
easily removed, unit level
most shelters contain sensitive electronic equipment that cannot be
maintenance and repair will Primarily involve shelter exteriors or
easily accessible interior areas, unless floors, ceilings or
which can jeopardize operation of the equipment. The
for repair if any of the following conditions exist:
a.
Panel damage spans a structural member.
walls have evidence of water intrusion
shelter shall be returned to the depot
b.
Replacement of an entire wall, ceiling, or floor is required.
c.
Extensive equipment removal beyond the capability of the using unit is required.
d.
Welding is required,
e.
Damage to a structural member is severe enough
especially in edge or corner areas.
to cause distortion of a wall,
f.
Lift, tow, or tiedown fittings or corner castings are damaged severely enough to
indicate possible damage to the underlying structural member.
3-7
