TM 55-4920-432-13&P
4-41. OIL RESERVOIR
4-41
THIS TASK COVERS:
REMOVAL AND INSTALLATION
Initial Set-Up:
Personnel Required:
Personnel Required: 68F Aircraft Electrician
or
35H TMDE Support Specialist
Tools/Test and Equipment:
Tool kit (B2) or Shop Set (B4)
Material/Parts:
Oil Reservoir, Tape (D9)
Equipment Condition:
Power disconnected, control panel open
1.
REMOVAL:
a.
Disconnect rigid pressure lines (1, 2, 3 & 4) from fitting on oil reservoir (5).
b.
Remove cap (6).
NOTE
Do not tip tester with oil in the reservoir to avoid flooding check valve.
c.
Remove screws (7) from bottom of chassis securing oil reservoir (5).
d.
Remove oil reservoir.
e.
Remove check valve assembly (8) and pour oil from reservoir
f.
Remove fill and run selector valve assembly (9).
g.
Remove fitting (10).
2.
INSTALLATION:
a.
Apply tape (D9) to fitting threads.
b.
Install fitting (10) to oil reservoir (5).
c.
Install fill and run selector valve assembly (9) to reservoir.
GO TO NEXT PAGE
4-60
