TM 10-5411-206-14
5-11. Skid Assemblies and Mounting Brackets.
This task covers:
Replace
INITIAL SETUP
Tools
MaterialsParts
General Mechanic’s Automotive Tool Kit
Sealer (Item 29 or 30, Appendix D)
SC 5180-90-CL-N26
Rivnuts, Various
Electronic Equipment Shelter Tool Kit
TK-144/G
Personnel Required
Four
Replace. (figure 5-6)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
NOTE
The shelter has three skid assemblies and three mounting brackets. The procedure is the
same for all three, except where noted.
Lift shelter and load it onto blocks high enough to allow ample clearance between skid assemblies and
floor for hardware removal and installation. (Refer to paragraph 3-5 for lifting and loading instructions.)
Remove six hex head bolts (1), six hex nuts (2) and twelve flat washers (3) and remove skid assembly
(4) from mounting bracket (5).
Remove eight socket head screws (6), 48 hex head screws (7 and 8), four flat washers (9) and four
lockwashers (10) and remove mounting bracket (5) from shelter floor.
NOTE
Shims (12 and 13) are only used with center mounted skid mounting bracket.
Remove shims (11 through 13). Record number of shims (11) removed.
Inspect rivnuts and replace if necessary (para 3-9.b).
Position shims (11 ) on ends of mounting bracket (5).
NOTE
Use same number of shims removed (step (4)).
Shims (12 and 13) are only used with center mounted skid mounting bracket.
Position one shim (12) on each end of mounting bracket (5) on top of shims (11). Place shim (13) on
mounting bracket. Make sure all mounting holes line up.
5-14
