TM 10-5411-207-14
CHAPTER 3
UNIT MAINTENANCE INSTRUCTIONS
Subject
Section
Page
Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . I
3-1
Repair Parts, Special Tools, TMDE, and Support Equipment . . . . . . II
3-1
Service Upon Receipt . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . III
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Maintenance Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3-7
Preparation for Shipment and Storage . . . . . . . . . . . . . . . . . . . . . . .
3-61
3-1
3-5
IV
V
VI
Section I. LUBRICATION
3-1.
Lubrication Instructions. Lubricate door hinges, latches and locking mechanisms,
door brace assemblies, roof access steps, and lifting and towing bracket assemblies to prevent
rust and corrosion. Check these parts frequently to be sure they are adequately lubricated.
Lubricate with Solid Film Lubricant, MIL-L-23398 (Item 22, Appendix D).
Section II. REPAIR PARTS, SPECIAL TOOLS, TMDE,
AND SUPPORT EQUIPMENT
Subject
Para
Page
Common Tools
3-2
3-1
Special Tools, TMDE, and Support Equipment. . . . . . . . . . . . . . . . . .. . . . 3-3
3-1
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-4
3-1
3-2.
Common Tools. A complete list of common tools and tool kits is given in Section
III of Appendix B, Maintenance Allocation Chart.
3-3.
Special Tools, TMDE, and Support Equipment. All special tools, TMDE, and
support equipment are listed in Section III of Appendix B, Maintenance Allocation Chart, and
in the Repair Parts and Special Tools List manual, TM 10-5411-207-24P, S-280C/G Shielded
and S-280C/G Unshielded Electrical Equipment Shelters.
3-4.
Repair Parts. Repair parts for unit maintenance of the shelter are listed and
illustrated in TM 10-5411-207-24P.
Section III. SERVICE UPON RECEIPT
Subject
Para
Page
Service Upon Receipt of Material . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-5
Site Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-6
3-1
3-4
3-5.
Service Upon Receipt of Material. Inspect the shelter for damage incurred dur-
ing shipment. If the shelter has been damaged, report the damage on SF 361 Transportation
Discrepancy Report (TDR). If the drain plug has been loosened for shipment, tighten it. If
the shelter is crated or pallet-mounted, refer to the end item technical manual for unpacking
instructions. If it is necessary for the shelter to be loaded onto a truck or transferred from
one truck to another, lift, load, and secure the shelter as follows:
Change 2 3-1
