TM 5-6350-280-10
Figure 2-6 System Summary Area (Typical).
2.5.5 Basic ANG Operation. When required, refer to paragraph 2.4.1 and power on the AMG.
NOTE
•
When the AMG program is started, an initialization screen appears. This screen is
displayed only during program initialization. When the program is loaded, the screen
automatically clears to the Remote Area Status Changes Screen.
•
The audible alarm only requires to be silenced once for all status changes that have
occured. Any status changes occuring after silencing will cause the alarm to sound
again.
a.
When an audible alarm sounds, Press <Fl> to silence audible tone.
b.
Check the System Summary Area (figure 2-6) for the type of status change. When the status change has
occurred in a remote monitored area, proceed to step c. If the status change is indicated in the monitor area
proceed to step j. Any communications (COM) alarms should be reported to maintenance.
c.
Press <F7> to ensure 'Remote Area Status Changes Screen' is displayed.
d.
Observe screen for flashing text. Select area flashing with highest priority by entering the area number on the
command line and press <ENTER>.
e.
Press <F6> to select Remote Area Notes screen and follow instructions for type of alarm or status change.
f.
Press <Fl> to acknowledge each alarm.
g.
Repeat steps c through f for any remaining remote alarms.
h.
Press <F7> to select Remote Area Status screen.
NOTE
•
When remote area alarm has been cleared it will change to lower case.
•
Selected area is displayed in command area.
i.
When alarm is in lower case letters, reset area as follows:
(1)
Select area.
(2)
Press <F2> to reset alarm.
(3)
Repeat this step as remaining alarms change to lower case.
j.
When AMG status change occurs, press <F4> to select Monitor Area Status screen. Press <Fl> to
acknowledge all status changes.
k.
Observe type of alarm or maintenance action required. Refer to chapter 3 for maintenance.
2-17
