TM 5-6350-280-10
2.5.6 Setup Node of Operation. The Setup Mode is only used by designated personnel that have access to the
password. The setup mode is used to setup or change the configuration file of the AMG software. Access to the Setup is
provided by pressing <F10>. When <F10> is pressed, a prompt for password is displayed in the command area. After
the password prompt is accessed, either enter the correct password or press the <Esc> key. Do not attempt to enter a
password unless you are authorized to do so. If the wrong password is typed and <ENTER> is pressed, the time, date,
and illegal attempt to gain access is printed on the status report to the printer. Each illegal attempt is recorded. When a
correct password is typed and <Enter> is pressed, access to the setup menus is granted. Detailed instructions for
initializing setup are contained in paragraph 2.3. To make changes after initialization enter the correct password and
perform steps c. through m. of paragraph 2.3.
2.6 DECALS AND INSTRUCTION PLATES.
The decals, labels, and identification plates are shown in Figure 2-7 thru Figure 2-10.
Figure 2-7 Location of UPS Labels.
Figure 2-8. Caution Labels on UPS.
Change 1 2-18
