TM 55-4920-432-13&P
SECTION V - MAINTENANCE PROCEDURES
3-15 FUSE - REPLACE
3-15
THIS TASK COVERS:
REMOVAL AND INSTALLATION
lnitial Set-Up:
Personnel Required:
68F Aircraft Electrician
Tools/Test and Support Equipment:
Shop Set (B4)
Parts:
Fuse, 5 AMP., P/N 27F697
Equipment Condition:
Power disconnected.
1
REMOVAL
a.
Remove fuse holder cap (1) from fuse holder body (2) turn 180 degrees counterclockwise.
b.
Pull out holder cap (1) and remove fuse from fuse holder body (2).
c.
Visually inspect fuse to see if it needs to be replaced.
2
INSTALLATION
a.
Remove control panel fasteners (3) with screwdriver by turning counterclockwise (Two places).
b.
Open control panel and get fusefrom spare fuse holder on back side of control panel. Fuse is
located under control panel handle.
c.
Close control panel and turn fasteners (3) clockwise.
d.
Install fuse into fuse holder cap (1) and place it into fuse holder body (2). Press down while turning
180 degrees clockwise.
GO TO NEXT PAGE
3-10
