TM 55-4920-432-13&P
4-16
ALTIMETER
4-16
THIS TASK COVERS:
REMOVAL AND INSTALLATION
Initial Set-Up:
Personnel Required:
68F Aircraft Electrician
or
35H TIDE Support Specialist
Tools and Equipment:
Tool kit (B2) or Shop Set (B4)
Material/Parts:
Altimeter, Tape (D9)
References:
TB 43-180
Equipment Condition:
Power disconnected, control panel open
1.
REMOVAL
a.
Disconnect hose and fitting from end of altimeter.
b.
Remove three nuts (1), lock washers (2), and flat washers (3) from inside tester.
c.
Remove three screws (4) securing altimeter(s) to control panel (6).
d.
Remove altimeter (5) from tester control panel (6).
2.
INSTALLATION
a.
Install altimeter (5) in control panel (6) and align mounting holes.
b.
Secure altimeter (5) to control panel (6) with three screws (4) from outside tester and install three
washers (3), lock washers (2), and nuts (1).
c.
Apply tape (D9) to fitting threads.
d.
Connect hose and fitting to port at end of altimeter.
FOLLOW ON MAINTENANCE
Calibration (TB 43-180)
Performance check (para. 2-5)
GO TO NEXT PAGE
4-10
