TM 10-5411-206-14
3-14. T-Latches and Holders.
This task covers:
Replace
INITIAL SETUP
Tools
General Safety Instructions
General Mechanics Automotive Tool Kit
WARNING
SC 5180-90-CL-N26
Drilling creates metal chips which may enter eyes
Materials/Parts
and cause serious injury. Eye protection is
required.
Sealer (Item 29 or 30, Appendix D)
Rivets, various
Goggles (Item 38, Appendix D)
Gloves (Item 12, Appendix D)
NOTE
The shelter has two T-latches. Replacement procedures are the same for both.
Replace. (figure 3-12)
(1)
(2)
(3)
(4)
Drill out four rivets (1) and remove T-latch (2). (Refer to paragraph 3-9a. for rivet removal instructions.)
Remove four screws (3), four flat washers (4), four lockwashers (5) and four nuts (6) and remove latch
holder (7) from shelter wall.
Position latch holder (7) on shelter wall and fasten with four screws (3), four flat washers (4) four
lockwashers (5) and four nuts (6).
Position T-1atch (2) on shelter and fasten with four rivets (l). (Refer to paragraph 3-9a. for rivet
installation instructions.)
Figure 3-12. T-Latch and Holder Replacement.
3-23