TM 10-5411-206-14
CHAPTER 5
GENERAL SUPPORT MAINTENANCE INSTRUCTIONS
Subject
Section
Page
Repair Parts, Special Tools, TMDE and Support Equipment . . . . . . . . . . . . . . . . . . . . . . . I
5-1
General Support Maintenance Procedures . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .II
5-1
Section I. REPAIR PARTS, SPECIAL TOOLS, TMDE AND SUPPORT EQUIPMENT
Subject
Para
Page
Common Tools . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . . . .5-1
5-1
Special Tools, TMDE and Support Equipment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-2
5-1
Repair Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-3
5-1
5-1. Common Tools. A complete list of common tools and tool kits is given in Section III of Appendix B,
Maintenance Allocation.
5-2. Special Tools, TMDE and Support Equipment. There are no special tools or equipment needed
to maintain the shelters.
5-3. Repair Parts. Repair parts for general support maintenance of the shelters are listed and illustrated in
TM 10-5411-206-24P.
Section II. GENERAL SUPPORT MAINTENANCE PROCEDURES
Subject
Para
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-4
Surface Preparation, Priming and Painting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-5
Door Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-6
Towing Eye Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-7
Lifting Eye Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-8
RFI/EMI Shielding Gaskets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-9
Wall and Ceiling Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-10
Skid Assemblies and Mounting Brackets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-11
Page
5-1
5-1
5-2
5-4
5-6
5-8
5-10
5-14
5-4. General. This section contains maintenance procedures which are the responsibility of general support
maintenance, as authorized by the Maintenance Allocation Chart (appendix B). The general maintenance
information given for unit level maintenance also applies to intermediate general support level maintenance. This
information is contained in paragraph 3-8.
5-5. Surface preparation, Priming and Painting. All bare metal shall be painted to prevent corrosion.
Touch up small dents and chips. Repaired sections of panels must be prepared with a corrosion protection primer
before painting. Do not attempt to repaint large areas such as complete exterior interior or ceiling. Detailed
priming and painting instructions can be foundin TM 43-0139.
5-1
