TM 10-5411-206-14
5-8. Lifting Eye Assemblies.
This task covers:
a. Remove
b. Disassemble
c. Assemble
d. Install
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 29 or 30, Appendix D)
SC 5180 -90-CL-N26
Electronic Equipment Shelter Tool Kit TK-144/G
NOTE
The shelter has one lifting eye assembly at each top corner. This procedure is typical for
all four lifting eye assemblies.
a. Remove. (figure 5-3)
(1) Remove four cap screws (1), four flat washers (2), four lockwashers (3) and 11 socket head screws (4
and 5) and remove lifting eye assembly (6 through 10).
(2) Remove and retain shims (11 and 12).
(3) Inspect condition of rivnuts (13) and replace if necessary (para 3-9.b).
b. Disassemble. (figure 5-3)
(1) Remove setscrew (6).
(2) Unscrew and remove swivel pin (7) from ring assembly (8).
(3) Pull ring assembly (8) out of casting (9) and remove spacer (10).
c. Assemble. (figure 5-3)
(1) Position spacer (10) on casting (9) and insert threaded end of ring assembly (8).
(2) Thread swivel pin (7) onto ring assembly (8) inside casting (9). Secure in place with setscrew (6).
(3) Apply lubricant liberally to interior surfaces of swivel pin (7) and ring assembly (8).
d. Install. (figure 5-3)
(1) Coat both sides of shims (11 and 12) and entire inside surface of casting (9) (except for area around
swivel pin (7)) with sealer.
(2) Position shims (11 and 12) against inside of casting (9) so that mounting holes line up.
5-6
