TM 10-5411-207-14
3-12.
Drip Molding (Above Door).
This task covers:
a.
Inspect
b.
Repair
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
Blind Riveter
Blind Rivets
a.
Inspect. (Figure 3-11)
(1) Inspector damaged drip molding (2).
(2) Inspector missing blind rivets (1).
b.
Repair. Repair of the drip molding consists of replacement
of the missing, damaged, or
defective parts,
(1)
(2)
(3)
(4)
(5)
as necessary, according to the following procedure:
Remove seven blind rivets (1) securing drip molding (2) to shelter. (Refer to
paragraph 3-9.a. for rivet removal instructions.)
Remove drip molding.
Position new drip molding (2) on shelter so that mounting holes line up.
Fasten with seven blind rivets (1). (Refer to paragraph 3-9a. for rivet
installation instructions.)
Apply a continuous bead of sealer around edge of drip molding.
Figure 3-11. Drip Molding Removal/Installation.
3-21
