TM 10-5411-207-14
3-13.
Hand Hold (Roof).
This task covers:
a.
Inspect
b.
Repair
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
Blind Riveter
Blind Rivets, Various
a.
Inspect. (Figure 3-12)
(1) Inspect for damaged or non-functioning bail handle (5).
(2) Inspector missing blind rivets (1, 2, and 4).
b.
Repair. Repair of the hand hold consists of replacement of the missing, damaged, or
defective parts, as necessary, according to the following procedure:
(1)
(2)
(3)
(4)
(5)
(6)
NOTE
If only bail handle (5) is damaged, perform steps (2) and (3) below.
Remove three blind rivets (1) and seven blind rivets (2) securing hand hold (3) to
roof of shelter and remove hand hold. (Refer to paragraph 3–9.a. for rivet
removal instructions.)
Drill out five rivets (4) securing bail handle (5) to hand hold (3) and remove bail
handle.
Secure bail handle (5) to hand hold (3) with five rivets (4). (Refer to paragraph
3-9a. for rivet installation instructions.)
Place hand hold at proper position on shelter roof.
Attach hand hold (3) to shelter roof with three blind rivets (1) and seven blind
rivets (2).
Apply a continuous bead of sealer around edge of bail handle and edge of hand
hold pan.
3-22
Change 1
