TM 55-4920-432-13&P
SECTION IV - TROUBLESHOOTING
4-11 GENERAL
4-11
A list of possible failures to the Pitot and Static Systems Tester as well as probable cause and corrective action
are shown in the following fault isolation block diagrams. Corrective actions, as shown in the following trouble
shooting diagram, are outlined in the applicable removal/replacement paragraphs in the text of this manual.
4-12 PIVOT AND STATIC SYSTEMS TESTER INSPECTION/FAULT
4-12
ISOLATION
Initial Set-Up:
Personnel Required:
68F Aircraft Electrician
or
35H, Test, Measurement
Diagnostic Equipment (TMDE)
Support Specialist
Tools/Test and Support Equipment:
Tool Kit (B2)
or Shop Set (B4)
Equipment Condition:
Tester on Work Bench
4-4
