TM55-4920-432-13&P
4-26 PILOT LAMP SOCKET
4-26
THIS TASK COVERS: REMOVAL AND INSTALLATION
Initial Set-Up:
Personnel Required:
68F Aircraft Electrician
or
35H TMDE Support Specialist
Tools and Equipment:
Tool kit (B2) or Shop Set (B4)
Material/Parts:
Pilot lamp socket, Pilot lamp bulb
Heat Shrink (D5), Solder (DS8)
Equipment Condition:
Power disconnected, control panel open
1.
REMOVAL:
a.
Remove wires from lamp socket leads.
b.
Remove mounting nut (1), washer (2) from the lamp socket, remove pilot lamp socket from
operator panel (3).
c.
Hold the lamp socket (4) and remove the pilot lamp (5) turning it counterclockwise.
2.
INSTALLATION:
a.
Turn the pilot lamp (5) clockwise into the lamp socket (4) hand tighten.
b.
Install the pilot lamp into panel and secure with mounting washer (1) and nut (2).
c.
Solder two wire to lamp socket using solder (D8), and cover connections with heat shrink (D5).
Performance check (para. 2-5)
GO TO NEXT PAGE
4-30
