TM 55-4920-432-13&P
4-34. CAPACITOR
4-34
THIS TASK COVERS: REMOVAL AND INSTALLATION
Initial Set-Up:
Personnel Required:
68F Aircraft Electrician
or
35H TMDE Support Specialist
Tools and Equipment:Tool kit (B2) or Shop Set (B4)
Material/Parts:
Capacitor
Equipment Condition: Power disconnected, control
panel open
1.
REMOVAL:
a.
Remove two screws (1) that secure the terminated wire connections and disconnect them.Install
screws (1) back into capacitor (2).
b.
Loosen capacitor clamp screw (3) from capacitor clamp.
c.
Remove capacitor.
2.
INSTALLATION:
a.
Install capacitor (2) into clamp and tighten clamp screw (3) to hold capacitor.
NOTE
Insure correct polarity when connecting electrical wiring.
b.
Remove screws (1) from capacitor (2), and connect terminated wires to capacitor.
Performance check (para. 2-5)
GO TO NEXT PAGE
4-46
