TM 55-4920-432-13&P
4-36. EMI FILTER
4-36
THIS TASK COVERS: REMOVAL AND INSTALLATION
Initial Set-Up:
Personnel Required:
68F Aircraft Electrician
or
35H TMDE Support Specialist
Tools and Equipment:Tool kit (B2) or Shop Set (B4)
Material/Parts:
EMI Filter
Equipment Condition: Power disconnected, control
panel open
1.
REMOVAL:
a.
Remove five nuts (1), five washers (2) securing wire terminations to EMI filter (3). Disconnect wires
from EMI filter leads.
b.
Remove two mounting nuts (4), lockwashers (5) flat washers (6) from mounting studs.
c.
Remove EMI filter (3) from chassis assembly.
2.
INSTALLATION:
a.
Install EMI filter (3) on mounting studs in chassis.
b.
Secure EMI filter to chassis with two flat washers (6), lockwashers (5) and nuts (4). Tighten to hold
EMI filter.
c.
Position wire on EMI filter and secure with five washers (2) and nuts (1).
Performance check (para. 2-5)
GO TO NEXT PAGE
4-50
