TM 55-4920-432-13&P
4-37. POWER CONNECTOR
4-37
THIS TASK COVERS:
REMOVAL AND INSTALLATION
Personnel Required:
68F Aircraft Electrician
or
35H TMDE Support Specialist
Tools/Test and Equipment:
Tool Kit (B2) or Shop Set (B4)
Material/Parts:
Connector, Heat Shrink (D5), Solder (D8)
Equipment Condition:
Power disconnected, control panel open
1.
REMOVAL:
a.
Remove wires from connector pins.
b.
Remove connector cap (1) from power connector (2).
c.
Remove four mounting screws (3) from power connector.
d.
Remove power connector (2).
2.
INSTALLATION:
a.
Install connector (2) in chassis assembly and secure with four screws (3).
b.
Install heat shrink on wires and wires on connector solder cups (See FO-1 thru FO-3).
c.
Solder wires in cups, and install shrink tubing over solder connections.
d.
Install cap (1) on power connector.
Performance check (para. 2-5)
GO TO NEXT PAGE
4-52
