TM 10-5411-207-14
3-19.
Emergency Exit Panel Assembly (cont).
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
Remove and retain nut (3) and two nylon flat washers (4) securing each of the
four latches (5) and remove latches.
Remove two rivets (6) attaching each of the four stud plate assemblies (7) to
panel and remove stud plate. (Refer to paragraph 3-9a. for blind rivet removal
instructions.)
Remove two rivets (8) and a rivet (9) attaching each of the four strike plates
(10) to cover, and remove strikes.
Reach behind panel, take hold of each air filter (11), pull out of position and
remove.
Remove four rivets (12) attaching the divider strip (13) to back of panel and
remove strip.
Remove two rivets (14) attaching each corner gusset (15) to back of panel and
remove gussets.
Remove and retain 92 phillips head screws (16) attaching the intake louver
assembly (17) and (Shielded) RFI/EMI filter (17.1) to panel frame and remove
four retaining strips (18 and 19), louver (17), (Shielded) RFI/EMI filter (17.1),
and (Shielded) knitted wire mesh tape (17.2).
Remove sealer from retaining strips (18 and 19), louver (17) and panel frame.
e.
Assemble. (Figure 3-22)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Position (Shielded) knitted wire mesh tape (17.2), (Shielded) RFI/EMI filter
(17.1), intake louver assembly (17) and four retaining strips (18 and 19) in
place inside panel frame and secure with 92 phillips head screws (16).
Position each of the four corner gussets (15) in place on the back of the panel
frame and secure each with two blind rivets (14).
Position the divider strip (13) in place and secure to panel frame with four
blind rivets (12).
Insert two air filters (11) in place in back of panel.
Place each of the four strike plates (10) in position and secure tO panel cover
with three blind rivets (8 and 9).
Position each of the four stud plate assemblies (7) in place on panel flange and
secure each with two blind rivets (6).
Place a nylon flat washer (4) over the stud of each stud assembly (7), then a
latch (5), and secure in place with a nylon flat washer (4) and nut (3).
Change 2
3-41
