TM 10-5411-207-14
3-20.
Door Latch Assembly (cont).
(7) Punch out spring pin (11) and release the roller extension (12) and roller latch
(13) from latch arm (14).
(8) Punch out spring pin (1) and release flat washer (2), pin (18), and latch rod
assembly (4 and 5).
(9) Remove nut (19) to release washer (20), spacer (21), latch arm assembly (10),
spacers (22, 24, and 25), latch arm detent (23), (at the bottom latch installation
only), and bolt (26).
(10) Remove and retain a phillips head screw (27) and lock washer (28) attaching
padlock and chain (29) to escutcheon plate (30) and remove padlock.
(11) Remove and retain two phillips head screws (31) and remove escutcheon plate
(30) from door panel.
d.
Assemble.
(1)
(2)
(3)
(4)
(5)
(6)
NOTE
Assembly procedures are similar for top and bottom sections of door
latch assembly.
Position escutcheon plate (30) in place on door panel and secure with two
phillips head screws (31).
Place mounting end of padlock and chain (29) over mounting hole and secure
with a phillips head screw (27) and lock washer (28).
Place roller extension (12) and roller latch (13) on to latch arm (14) and secure
with spring pin (11).
NOTE
When installing the latch arm detent (23) at the bottom section of the
assembly, have the latch mechanism fully open, so that the raised
surface is engaged in the hole of the latch arm assembly (10). Then
secure all components by tightening nut (19).
Place bolt (26) through hole on door and insert spacers (24 and 25), latch arm
detent (23), spacer (22), (at top of installation), latch arm assembly (10), space
(21), and washer (20), and secure with nut (19).
Put washer (2) onto pin (18), insert pin (18) through hole on rod latch (4 and 5),
and secure with spring pin (1).
Insert handle shaft sleeve (17) into hole from outside of door panel and secure
with bearing sleeve nut (16) from the inside of panel.
3-44
Change 1
