TM 5-6350-280-23&P
g.
Install six screws (1) in front cover (2) and six screws (1) in rear cover (2).
WARNING
Do not attempt to lift the UPS without mechanical lifting device. The UPS weighs
208 lbs and requires a mechanical lifting device. Failure to observe this warning
may result in personal injury.
h.
Remove UPS.
4.6.1.2 Installation.
WARNING
Do not attempt to lift the UPS without mechanical lifting device. The UPS weighs
208 lbs and requires a mechanical lifting device. Failure to observe this warning
may result in personal injury.
a.
Position new UPS in place.
b.
Connect power cable to back of UPS. Make sure voltage input selection is correct.
c.
Remove six screws (1) from front cover (2) and six screws (1) from rear cover (2).
d.
Remove front cover (2) and rear cover (2).
WARNING
·
Do not lift batteries alone. Each battery weighs 77 lbs and requires two
personnel to lift battery.
·
Do not touch batteries or allow terminals to come in contact with metal surface.
Each battery has a high current potential that can be fatal. Always work with
another person nearby who is familiar with hazards of electrical equipment and
is competent in administering first aid.
·
Failure to observe these warnings could result in personal injury or death and
equipment damage.
e.
Refer to the connection diagram and position battery number 1 on shelf.
f.
Connect battery positive terminal then negative terminal as follows:
(1)
Install bolt (8), flat washer (7), red lead (9), flat washer (6), lock washer (5), and nut (4).
(2)
Remove tags.
(3)
Refer to the connection diagram to connect and install remaining batteries. Always connect from positive to
negative according to connection diagram.
g.
Connect battery input quick disconnect connector.
h.
Install front and rear covers (2) using six screws (1) for each cover (2).
4-27
