TM 5-6350-280-23&P
4.6.9.2 Installation.
a.
Align mounting holes of new backplane with mounting holes of drawer assembly.
b.
Install ten flat washers (4), screws (3), lock washers (2), nuts (1), and Power Cable (9).
c.
Assemble the following:
(1)
Connect Power Cord Assembly paragraph 4.6.4.
(2)
Connect RX-TX Cable Assembly paragraph 4.6.5.
(3)
Connect Area Input Cable Assembly paragraph 4.6.6.
(4)
Install Data Receiver CCAs paragraph 4.6.7.
(5)
Install CPU CCAs paragraph 4.6.8.
(6)
Install EMI shield and close drawer assembly, paragraph 4.6.3.
d.
Refer to TM 5-6350-280-10 and power on equipment.
4.6.10 DC Power Supply Maintenance.
4.6.10 DC Power Supply Maintenance
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Tools
Material/Parts
Electronic System Maintenance Tool Kit
DC Power Supply (Appendix C, figure 4,
(Appendix B, Section III, item 1)
item 6)
Equipment Conditions
General Safety Instructions
Equipment shutdown (TM 5-6350-280-10)
Do not work on equipment without
Drawer assembly open (paragraph 4.6.3)
following standard shop safety
Data Receiver CCAs removed (paragraph
precautions.
4.6.7)
CPU Card removed (paragraph 4.6.8)
4-42
