TM 10-5411-206-14
Table 4-1. Troubleshooting (cont).
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Step 3. Check condition of RFI/EMI filter in door.
Replace damaged or missing filter (para 4-15).
Step 4. Check for missing hinge shims.
Replace missing shims (para 4-17).
Step 5. Check condition of metal door gasket.
If replacement is required, notify higher level of maintenance.
Section III. DIRECT SUPPORT MAINTENANCE PROCEDURES
Subject
Para
Page
General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5
Surface Preparation, Priming and Painting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-6
Drip Mold . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-7
Data Plates . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-8
Door Stop Angle . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-9
Floor Tread . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-10
Door Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-11
Weather Gaskets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-12
Drip Cap . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-13
Emergency Exit Latches, Strikes and Stud Plate Assemblies . . . . . . . . . . . . . . . . . . . . . . . . 4-14
Intake Louver Assembly and RFI Fitter . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-15
Door Knob Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-16
Door Hinge Assemblies . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-17
Door Skin . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-18
RFI/EMI Components . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-19
Wall Floor and Ceiling Panels . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-20
4-3
4-3
4-4
4-5
4-6
4-7
4-8
4-9
4-11
4-12
4-14
4-16
4-18
4-20
4-21
4-22
4-5. General This section contains maintenance procedures which are the responsibility of direct support
maintenance, as authorized by the Maintenance Allocation Chart (appendix B). The general maintenance
information given for unit level maintenance also applies to direct support level maintenance. This information is
contained in paragraph 3-8.
4-6. Surface Preparation, Priming and Painting. All bare metal shall be painted to prevent corrosion.
Touch up small dents and chips. Repaired sections of panels must be prepared with a corrosion protection primer
before painting. Do not attempt to repaint large areas such as complete exterior, interior ceiling. Detailed
priming and painting instructions can be found in TM43-0139.
4-3