TM 10-5411-206-14
4-7. Drip Mold.
This task covers:
Replace
INITIAL SETUP
Tools
General Safety Instructions
Electronic Equipment Shelter Tool Kit TK-1 44/G
WARNING
General Mechanics Automotive Tool Kit
SC 5180-90-CL-N26
Drilling creates metal chips which may enter eyes
Blind Riveter
and cause serious injury. Eye protection is required.
Materials/Parts
Sealer (Item 29 or 30, Appendix D)
Rivets, Various
Goggles (Item 38, Appendix D)
Replace. (figure 4-1)
(1) Drill out seven rivets (1 and 2) and remove drip mold (3) from shelter wall. (Refer to paragraph 3-9.a for
rivet removal instructions.)
NOTE
The last two rivet locations on each end of drip mold require longer grip range rivets than
the middle three locations.
(2) Position drip mold (3) on shelter wall and fasten with four long rivets (1) and three short rivets (2). (Refer
to paragraph 3-9.a for rivet installation instructions.)
Figure 4-1. Drip Mold Replacement.
4-4