TM 10-5411-206-14
4-10. Floor Tread.
This task covers:
Replace
INITIAL SETUP
Tools
General Safety /nstructions
Electronic Equipment Shelter Tool Kit
TK-144/G
General Mechanic’s Automotive Tool Kit
SC 5180 -90-CL-N26
Materials/pads
Solvents are flammable. Keep away from heat and
open flames. Avoid eye and skin contact and
breathing of vapors. Use protective goggles and
gloves. Use in a well-ventilated area. Use in
accordance with manufacturer’s instructions.
Solvent (Item 37, Appendix D)
Rubber Floor Matting (Item 19 or 20, Appendix D)
Gloves (Item 12, Appendix D)
Goggles (Item 38, Appendix D)
CAUTION
When removing floor tread that has been cemented down, be careful not to delaminate
shelter floor.
NOTE
When installing new floor tread inside shelter, it is not necessary to remove old, worn floor
tread that has been cemented down unless leaving it in place and covering it with new
tread material will interfere with equipment or racks. If old tread is not being removed,
omit steps (1) through (3).
(1) Remove old floor tread completely.
CAUTION
Do not permit solvent to penetrate through floor panels. Solvent may dissolve core
material.
(2) Remove residue using solvent. Wipe off solvent.
(3) Prime and paint floor (para 4-6).
(4) Cut new floor tread using 1/8 or 3/16 inch thick rubber floor matting. Lay new tread in place. Do not
cement in place.
4-7
Replace.
