TM 10-5411-207-14
3-21.
Keeper Assembly.
This task covers:
a. Inspect
b. Replace
INITIAL SETUP
Tools
Materials/Parts
General Mechanic’s Automotive Tool Kit
Sealer (Item 28, Appendix D)
a.
Inspect. (Figure 3-24)
(1) Inspect for wear and other physical damage.
(2) Inspect for secure mounting.
(3) Inspect latch lock assembly (3) for wear or damage.
b.
Replace. (Figure 3-24)
(1)
(2)
(3)
(4)
(5)
(6)
Remove and retain hex-head screw (1) and lock washer (2) from
hole of keeper assembly (3).
Remove and retain hex-head screw (4) and lock washer (2) from
top (upper)
bottom (lower)
hole of keeper (3) attaching each of the keepers (3) and shim (5) to wall and
remove.
If only latch lock assembly (6) has to be removed, remove and retain hex-head
screw (4) and lock washer (2) attaching the center keeper at the bottom (lower)
hole.
Position shim (5), and each keeper (3) in place and secure to shelter wall at top
hole using hex-head screw (1) and lock washer (2).
Secure keeper to
(2).
If only latch lock
mounting hole of
washer (2).
wall at bottom hole using hex-head screw (4) and lock washer
assembly (6) has to be installed, position in place over bottom
center keeper and secure using hex-head screw (4) and lock
3-47
