TM 5-6350-280-10
2.4. HARDWARE OPERATING PROCEDURES.
2.4.1 Power On.
Should equipment/system fail for any reason do not power on until maintenance has been notified.
Failure to observe this caution could result in equipment damage.
a.
At the UPS, refer to figure 2-1 and perform the following:
(1)
Set the UPS AC LINE INPUT BREAKER to ON.
(2)
Observe UPS AC LINE INPUT indicator is illuminated.
(3)
Set UPS BATTE RY BREAKER to ON.
(4)
Set UPS INVERTER OUTPUT BREAKER to ON.
(5)
Depress "OFF INVERTER ON" switch to ON.
(6)
After 2 seconds, observe UPS INV OUTPUT indicator illuminates.
b.
At the computer, refer to the manuals provided with the computer and figure 2-2 then perform the following:
(1)
Load paper in printer if required.
(2)
Apply power to computer.
(3)
Ensure computer power is on.
(4)
Apply power to monitor.
(5)
Observe that power indicator for monitor is illuminated.
(6)
Apply power to printer.
(7)
Observe that power indicator for printer is illuminated.
c.
Press <F5>to select the Remote Area Status screen. Observe screen until all remote areas being monitored are
green.
2.4.2 Shutting Down AMG.
Perform the following procedures:
a.
At the computer, refer to the manuals provided with the computer and figure 2-2 then perform the following:
(1)
Remove power from printer.
NOTE
When printer is turned off, audible alarm will sound and MAINT function will be indicated.
(2)
Observe that power indicator for printer is not illuminated.
(3)
Remove power from monitor.
(4)
Observe that power indicator for monitor is not illuminated.
2-10
