TM 5-6350-280-10
SECTION III. OPERATION UNDER USUAL CONDITIONS
2.3. ASSEMBLY AND PREPARATION FOR USE.
Assembly and preparation for use is performed by the maintenance and designated personnel. The designated
personnel assigns the password in the Setup Mode. Returning to the Secure Mode configures the application software.
To configure the application software for use, select the Setup mode as follows:
a.
When Remote Area Status Changes Screen of the Secure Mode screen appears, press <F10> and perform
following:
NOTE
The application software is password protected. The software provided with system has a default
password. The default password is "setup" in lower case letters. Since the AMG password is case
sensitive, the word "setup" must be in lower case letters. After the software is setup, the new password
must be used.
b.
Type <password> then press enter.
c.
When SETUP MENU of Setup Mode is displayed, select Module Setup as follows:
(1)
Press <2> or down arrow key (, ) to display Module Setup.
(2)
Press <Enter>.
NOTE
To monitor any remote area within a module the module for that remote area must be turned on.
d.
When Module Setup screen appears, use arrow keys (1 and 1) to select modules. Press space bar to change
status condition from off to on. Refer to table 1-2.
e.
Observe display and verify following:
(1)
Status indication for selected modules are "ON".
NOTE
A "." in the "A4 CCAs" column of the module set up screen indicates that the data receiver CCA is not in
communication with the central processing unit (CPU) CCA, not installed in the CMA, or is not properly
installed in the CMA.
(2)
“YYYYYYYY" is displayed under heading "A4 CCA's" of each selected module.
(3)
Version number is displayed under heading "SOFTWARE VERSION" of each selected module.
f.
Press <Esc> key.
g.
When SETUP MENU is displayed, select remote area setup by pressing <Enter>.
h.
When Remote Area Setup appears, use the up and down arrow (1 and 1) keys to select the area for data entry.
i.
When each area is selected, enter data for selected area as follows:
(1)
Use keyboard to enter title (30 characters) of location.
(2)
Press <Tab> key and enter number between 1 and 4 for priority of area. Highest priority is 1 and lowest
priority is 4.
(3)
Press <Tab> key and press space bar to set mode.
Change 1 2-7
