TM 5-6350-280-10
Table 2-2. Typical IBM-PC/AT Compatible Computer Controls and Indicators.
Item
Number
Description
Function
1
Personal Computer Power
When illuminated, indicates power is applied to
On Indicator
personal computer.
2
Personal Computer Power
Provides input power for personal computer.
ON/OFF switch
3
Printer Power ON/OFF
Provides input power for printer.
switch.
4
Printer Paper Feed.
Provides paper feed to the printer.
5
Printer ON LINE/OFF
Switch that places printer in ONLINE mode or
LINE Switch.
OFFLINE mode.
6
ON LINE indicator
Indicates printer is online.
7
POWER ON indicator
Indicates power is on to printer.
8
Keyboard
Provides input and command keys for personal
computer.
9
Monitor Power ON/OFF
Provides input power for monitor.
switch
10
Monitor Power On
When illuminated indicates power is applied to
Indicator
monitor.
2.1.4 Controls and Indicators J-SIIDS. The J-SIIDS is used in conjunction with the AMG. Refer to the J-SIIDS TM 5-
6350-250-14-1 for operation of the J-SIIDS.
SECTION II. PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS)
2.2 GENERAL.
Preventive Maintenance Checks and Services (PMCS) is systematic caring, inspecting, and servicing of equipment to
keep it in good operating condition. Always perform your PMCS, so it becomes a habit. Once you've had some practice,
you will quickly spot anything wrong.
NOTE
Since the AMG is normally operated 24 hours per day, there is usually no operator PMCS performed.
The AMG shall only be powered off in the event of an emergency that would result in equipment damage
or when directed to do so by designated authorized personnel.
a.
Be sure to perform your PMCS when you power on the equipment. Pay attention to WARNINGs, CAUTIONs, and
NOTEs.
b.
Do your BEFORE PMCS just before you power on the equipment.
c.
Use DA Form 2404 (Equipment Inspection and Maintenance Worksheet) to record any faults that you discover
before, during or after operation.
Your PMCS, table 2-3, lists inspections and care required to keep your equipment in good operating condition. It is set
up so you can make your BEFORE (B) OPERATION checks as you walk around the equipment.
The "INTERVAL" column of table 2-3 tells you when to do a certain check or service.
Change 1 2-5
